After installation of eScan, it asks me for a reboot. After reboot,the installation continues, but it yet again asks me for a reboot!!!How should I get over this problem?
Posted by - NA - on 26 June 2010 02:05 AM

A. This happens because of incomplete eScan installation or improper uninstallation of an earlier version of eScan.

To overcome this problem, do the following:

1. When eScan asks for reboot, *do not* click on Yes or No.
2. Come to the MSDOS prompt, change directory to the eScan\TEMP folder and
3. run the command "AVKWCTL /unregserver". Exit out of command prompt & then click on
Yes (for the question "reboot to continue installation?").

(6 vote(s))
Not helpful

Comments (0)
Post a new comment
Full Name:
CAPTCHA Verification 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).